Holder C-Trac C 9700 - Manual (Page 181)

C 9700 ... C 9.88 H
Operating Instructions
180 145 052
Maintenance Every 500 Service Hours
Changing the Hydraulic Oil Pressure Filter (Imple-
ment Hydraulics)
- Relieve any pressure in the hydraulic system by
operating the control levers.
- Remove the air filter housing (1) with a 24mm wrench.
ATTENTION
Observe the instructions for handling fuels
and lubricants.
- Clean the mating surface of the filter mount.
- Withdraw the pressure filter from the housing.
- Clean the housing.
- Coat the new seal with oil.
- Insert the new pressure filter in the air filter housing.
- Screw the air filter housing with a new seal in the filter
mount.
- Make a trial run and check for leaks.
- Check the hydraulic oil level.
Bild_137
1