Holder C-Trac C 9700 - Manual (Page 82)

145 052 81
C 9700 ... C 9.88 H
Operating Instructions
Special Operating Instructions
Stationary Operation
The tractor can be used for stationary operation, for example,
to drive a water pump via the PTO shaft.
ATTENTION
Place the tractor on level ground in both
directions.
- Attach the stationary equipment to the PTO shaft (1).
- Set the gearshift lever (with a mechanical gearbox the
gearshift and range selector lever) to the zero positi-
on.
- With a hydrostatic drive, set the program switch to 0.
- Apply the parking brake.
DANGER
Before switching on the PTO, make sure no-
one is standing in the vicinity of the tractor
and the rotating PTO shaft.
Hydraulic Oil Flow for Stationary Operation
When the tractor is stationary, hydraulic oil is available, for
example, for the operation of a hydraulic pump.
Max. oil quantity available .......... 22 litres (5.8 USGAL.)
ATTENTION
Before starting to drive after stationary
operation, first check the hydrostatic steering.
Turn the steering wheel fully to the right and
left several times to release air from the
steering system.
1