Holder C-Trac C 9700 - Manual (Page 91)

C 9700 ... C 9.88 H
Operating Instructions
90 145 052
Operating the Implements
Adjusting Catch Hook and Catch Hook Bar
You can adjust the catch hook laterally and longitudinally.
-
Measure the stand-off of the pins on your implement.
- Disengage the clamping screws (6) on both sides.
- Slide the catch hook laterally until the required distance
is reached.
- Retighten the clamping screws.
- Equipment of category II can be attached with the catch
hook (5) directly;
- For equipment of category I install the reducing
sleeves on the left and right.
Adjusting the Length of the Catch Hook Bar
- Disengage 2 locknuts and clamping screws (inside and
at bottom) on the lower link (2).
- Pull the linch pin out of the pin (1) and remove the pin.
- You can put the catch hook bar (3) in one of 3 positions.
- Insert the pin (1) in the hole and secure with the linch
pin.
- Retighten the locknuts and clamping screws.
DANGER
Make sure no-one is standing between the
tractor and implement.
- Drive the tractor to the implement to be picked up.
1 Pin with linch pin 4 Quick attach
2 Lower link support 5 Catch hook
3 Catch hook bar 6 Clamping screw
(adjustable) with 3 positions
- Steer the catch hooks (5) below the attaching pin of the
implement.
- Raise the front lift until the quick attach (4) closes and
engages.
2 3 4
6
1
5
Bild_53
Hole Position Used for
1st hole Front Category I and II
2nd hole Centre Category I
3rd hole Rear Optional attachments