Holder C-Trac C 9700 - Manual (Page 92)

Operating Instructions
145 052 91
C 9700 ... C 9.88 H
Operating the Implements
Adjusting the Upper Link Mount
The height of the upper link mount can be adjusted. The
required height depends on your implement.
1 Upper link support
2 Retaining spring
3 Top link pin
4 Height adjustment lever
5 Upper link mount
- Raise the height adjustment lever (4).
- Slide the upper link mount (5) to one of the 4 possible
positions.
- Release the height adjustment lever; the upper link
support engages.
- Pull the retaining spring (2) off the pin (3) and pull the
pin to the side.
- Adjust the upper link (8) to the proper length (screw in
or out by rotating the sleeve); secure the upper link
with the locking lever (7).
- Insert the pin though eyelet on the upper link and
secure the pin again with the retaining spring.
1 2 3
4 5
6
9
7
8