Heatiator C40 - Manual (Page 26)

Page 26 Heatilator • Constitution EPA Fireplace • 480-1091D 4/20/11
Unplug wire
harness before
removing fan
Remove nut
and lift out fan
Figure 4.9 Fan Motor
Fan Replacement Instructions
1. Remove the brick from the bottom of the fireplace and 3
of the back vertical bricks.
2. Remove the 2 screws from the access panel in the fire-
box floor. See Figure 4.8.
3. Pry up the access panel using the screwdriver slot and
completely remove the panel.
Removing the fan
1. Unplug the wire harness.
2. Lift fan from locating pins and remove. Repeat for
second fan if necessary. See Figure 4.9.
3. Connect new fan wires to wire harness.
4. Before installing the fan, make sure the grommets are
tightly in place. Insert the right fan and place over the
2 locating pins. Repeat for other fan. Figure 4.10
5. Re-install bottom panel or firebox access panel in
reverse order as described above.
6 Replace the brick that was removed.
7. Reconnect the power.
Figure 4.10 Installing Fans
Screwdriver Slot
Screws
Figure 4.8 Accessing Fan Motor