Home Automation 1503 - Manual (Page 24)

Home Automation, Inc.
22
the LARGER of the two cables
(marked PHONE LINE on the pro-
cessor board) plugged into the
Model 1503 Processor board to be
sure that it is firmly connected
at both ends.
To silence the trouble beeps on
the console, press the CANCEL key.
If more than one type of trouble
has occurred, the display will show
each one for two seconds. Pressing
the CANCEL key will acknowledge all
trouble indications.
If the trouble condition occurs
again, the console beeper will beep
again. See SET-UP MISC., BEEP ON
TROUBLE if you wish to disable the
beeper.
- SYSTEM FAILURE will be indicated
in the event that the console's
alarm functions are no longer
operational. This may indicate a
wiring problem to the console or
a more serious problem. Follow
the procedure above for reset-
ting the PTC fuses, or call your
installer for service.
CODES
All Model 1503 codes are 4 dig-
its in length. A code can be any
number from 0001 to 9999. Memorize
your codes! Don’t give them to
anyone who doesn’t need to know
them.
MASTER CODE
The Master code allows you to do
everything. The owner of the system
should have and use the master
code.
AUXILIARY CODES
The auxiliary codes can arm/
disarm security system, but cannot
change codes or be used to arm/
disarm the system from outside the
home over the telephone. The auxil-
iary code cannot be used to program
the security system mode (OFF,
HOME, ASLEEP, AWAY.) Finally, the
auxiliary codes cannot be used to
bypass or restore zones.
There are four auxiliary codes.
The number of the code (1 through
4) used is recorded in the event
log.
The first auxiliary code can be
switched on and off by time and day
of week if desired, making it ideal
for use as a maid's code. See SET-
UP CODES.
It is recommended that temporary
users, such as baby-sitters, be
assigned an auxiliary code.
DURESS CODE
If you are forced to disarm the
system against your will by an
intruder, disarm it as you normally
would, but use the DURESS CODE
instead of the master or auxiliary
code. The system will disarm nor-
mally. No sirens will sound, no
lights will flash, but the Model
1503 will perform a silent dial out
and say that this is a silent
alarm.
To stop a silent dial out, turn your
security system off the usual way,
pressing SECURITY-OFF then your master
code.
ACCESS CODE