Home Automation 1503 - Manual (Page 75)

73
Model 1503 Owner's
Manual
TELEPHONE ACCESS
The TELEPHONE ACCESS item allows
you to turn the local (in-house)
and remote telephone control fea-
ture on and off.
If set to ON, the Model 1503
will allow local and remote tele-
phone access as described in TELE-
PHONE CONTROL. If set to OFF, the
Model 1503 will not answer incoming
calls ever, and will not work on
the in house phones.
Dial outs will still occur, and
the system will operate normally
when the Model 1503 dials out.
If you do not have your Model
1503 connected to a phone line, set
TELEPHONE ACCESS to OFF to keep the
system from displaying ‘PHONE LINE
DEAD TROUBLE NOW’.
To turn TELEPHONE ACCESS off, press 0
then ENTER. To turn it back on, press 1
then ENTER.
The default setting for TELE-
PHONE ACCESS is ON.
ANSWER OUTSIDE CALL?
If you do not want your system
to answer outside calls, set this
item to NO. The local (in-house)
telephone control features will
still work, but the system will
never answer an incoming call.
To set ANSWER OUTSIDE CALL? to NO,
press 0 then ENTER. To turn it back on,
press 1 then ENTER.
The default setting for ANSWER
OUTSIDE CALL? is YES.
amount. The calculated time of
sunrise/sunset will change by four
minutes for every degree change in
longitude. To cause the calculated
sunrise/sunset to occur later,
enter a larger value for longitude.
Enter a smaller value for longitude
to cause the time to occur earlier.
It is not necessary to alter the
time zone to compensate for day-
light savings time, since the sys-
tem requires you to specify when
the time is set up whether daylight
savings time is in effect.
FREEZE ALARM ENABLED:
If there are one or more Model
1101 PESMs in a system, they can
also be used to detect a freeze
condition. See FREEZE ALARM.
To enable freeze alarm detection, press
1, ENTER. To disable this feature,
press 0, ENTER.
The default for FREEZE ALARM
ENABLED: is NO.
FREEZE ALARM ENABLED is the last
entry in the MISCELLANEOUS cat-
egory.
DIAL CATEGORY (VOICE DIALER)
To view or change items in the DIAL
category, press the SET-UP key, then
the DIAL key. To see the next item in
this category, press SHOW. To see the
previous item, press SET-UP.
To exit the set-up facility, press
CANCEL.