Home Automation 1503 - Manual (Page 37)

35
Model 1503 Owner's
Manual
The display will read “FRONT
PORCH OFF - 12:00 AM 11/08 *IF”.
Press TIME, AM.
The display will read “FRONT
PORCH OFF - SUNRISE 11/08 *IF”.
Now press the DATE-DAY key once.
The display will read “DATE: 11/
08 - MMDD DAY”
Enter 1, 1, 0, 9, then press ENTER.
(for 11/09, tomorrow.)
The display will read “FRONT
PORCH OFF - SUNRISE 11/09 *IF”.
Since this is what we want, press
ENTER.
The console will beep and the
display will go back to the program
menu. The front porch light will be
turned off on date 11/09 at sun-
rise. Once this program has run, it
will be deleted from memory auto-
matically since it is a one time
program.
EXAMPLE 3: Turn the Security system
to AWAY mode at 10:30 PM on 11/10.
From the PROGRAM menu (press the PROG
key if you’re at the time, date and
status display), press AWAY.
The display reads “ARM SYSTEM:
AWAY CODE *BYPASS #RESTORE.”
Enter your MASTER CODE. ONLY the master
code can program the security system
modes, the auxiliary codes cannot.
(You may also program the system
to bypass and restore zones, if
desired. To do so, press * or #,
then the zone number to bypass or
restore, then enter your master
code.)
The display will now read
“PROGRM AWAY 12:00 11/08 *IF.”
Press TIME, 1, 0, 3, 0, PM.
Press DATE-DAY 1, 1, 1, 0, ENTER.
The display will now read
“PROGRM AWAY 10:30 PM 11/10 *IF”.
At this point, we can save the
program by pressing ENTER, or press
CANCEL to skip saving the program
and go back to the PROGRAM menu.
Press CANCEL. The console will beep
once and go back to the PROGRAM
menu.
REPEATING PROGRAMS
Repeating programs are pro-
grammed by time and day of the
week. They do not delete them-
selves. They will run every day
that they are programmed to run
until you delete the program using
SHOW PROG DELETE. Three examples
are given.
EXAMPLE 4. Program Unit number 2
(your FRONT PORCH light) to come on
at sunset every day of the week.
From the time, date and status display,
press PROG, UNIT-NUMBER, 2 (or the SHOW
key twice), ON.
Press TIME, PM.
Press DATE-DAY TWICE.
The display will read “DAY(S):
ONCE 1-9 0=ONCE.” You can now
enter the days of the week that you