Home Automation 1503 - Manual (Page 69)

67
Model 1503 Owner's
Manual
ENTER. To remove a code, enter 0000 in
its place.
DURESS CODE
Press the SHOW key to advance the
display to NEW DURESS CODE:
If you are forced to disarm the
system against your will by an
intruder, use the DURESS code in-
stead of the master or auxiliary
code.
The alarm system will disarm
normally, except that a silent dial
out will be performed. The duress
code is always active, and can only
be used on the console and on an
in-house telephone to change the
security system mode.
To cancel a duress dial out, you
must arm or disarm the security
system using the master or valid
auxiliary code.
The duress code is NOT set at
the factory. Enter a duress code
immediately. Record and remember
the new Duress code.
ACCESS CODE
The ACCESS code allows remote
telephone access, but cannot be
used to arm or disarm the security
system. The access code cannot be
used on the console. The access
code can be used to stop the system
from making any further voice dial
calls.
HIGH SECURITY MODE
AUXILIARY CODE OFF TIME
Press the SHOW key to advance the
display to AUX CODE #1 OFF:
You may now enter the time and
day of week that the Auxiliary code
is turned off, or disabled.
To change the AUX CODE OFF time to 5:00
PM, Monday, Wednesday and Friday,
follow the steps in the example for AUX
CODE ON, substituting the time of 5:00
PM.
If you have followed the ex-
amples for AUX CODE ON and AUX CODE
OFF, your auxiliary code will be
valid between the hours of 8:00 AM
and 5:00 PM on Mondays, Wednesdays
and Fridays.
If you set both the AUX CODE ON
and AUX CODE OFF times to NEVER,
the AUX CODE will never be valid.
To turn your auxiliary code off, press
SET-UP 1(Codes), then press the SHOW
key to advance to AUX TIME ON:. Press
DATE/DAY, 0, ENTER. Then press CANCEL
to exit the SET-UP facility. Or, enter
0000 as the code.
AUXILIARY CODE 2
AUXILIARY CODE 3
AUXILIARY CODE 4
These codes can be given to fam-
ily members or others. They have
the same capability as AUX CODE #1,
but do not have an on time and off
time.
To enter a new auxiliary code, enter
the four digits of the code then press