Home Automation 1503 - Manual (Page 73)

71
Model 1503 Owner's
Manual
press ENTER.
ENTRY/EXIT CHIME
When ENTRY/EXIT CHIME is set to
YES, the console(s) will beep once
when a door on an entry/exit zone
is opened, even if the alarm system
is off. This lets you know when
children enter or leave the house,
etc.
If you wish to turn the ENTRY/EXIT
CHIME off, press 0 then ENTER to turn
the feature off. To turn it back on,
press 1 then ENTER.
The default setting for ENTRY/
EXIT CHIME: is YES.
BEEP ON TROUBLE?
If the Model 1503 detects
trouble with itself or one of the
zones connected to it, it will
display a message on the screen and
beep the console twice per second,
continuously (i.e. beep beep...beep
beep...). You can silence this
sound by pressing the CANCEL key.
However, if the trouble occurs
again, the beeper will start beep-
ing again.
If you do not wish to hear the beeping
sound when trouble occurs, set BEEP ON
TROUBLE? to NO by pressing 0 then
ENTER. To turn the feature back on,
press 1 then ENTER to set it to YES.
The display will still show the
trouble indication when BEEP ON
TROUBLE? is set to NO.
The default setting for BEEP ON
TROUBLE? is YES.
ON FOR ALARM UNIT NUMBERS
The ON FOR ALARM UNIT NUMBERS
are turned on when the alarm is
activated and the interior sounder
begins to sound. The factory de-
fault is 129, for ALL LIGHTS ON. If
you want appliances (a radio, for
example) to come on too, enter 129
and its unit number. Up to 6 unit
numbers (including 129 for ALL
LIGHTS ON) can be entered.
To enter new ON FOR ALARM UNIT NUMBERS,
enter each unit number, then press the
ENTER key once.
The console will NOT beep when
you press ENTER after a unit num-
ber.
When you have entered the last unit
number (up to 6 numbers are allowed,)
press enter twice.
The console will beep and the
new numbers will be redisplayed
indicating that they have been
accepted.
FLASH FOR ALARM UNIT
You may enter one unit number
that will flash on and off continu-
ously when the alarm is activated.
This should be an outside light to
alert neighbors and police to your
home if the alarm is activated.
The default FLASH FOR ALARM UNIT
is unit number 2. You may enter one
new number for the unit number you
wish to have flash, 0 for none, or
129 for ALL LIGHTS.
To change the FLASH FOR ALARM UNIT
number, enter the new unit number then