FUJITSU IMAGE SCANNER FI-486PRRE User Manual
Page 225
202
7.3 Setup Mode Details
22. Setting Interface
1) Press
(Next button) or
(Previous button) and let LCD display <Screen22>.
<Screen22>
2) At <Screen22>, press
(Left arrow button) or
(Right arrow button), and select
the type of interface.
Available interface settings are as follows:
By pressing
(Left arrow button), selection moves from (3) to (1).
By pressing
(Right arrow button), selection moves from (1) to (3).
(3) Press
(Enter button) and make the setting valid.
Press
(EXIT button) at the end and the LCD display goes back to [Ready]
screen.
HINT
The blinking item is the one selected.
(1)[Auto] is blinking:
If an interface board, either from third party or optional, is
installed in TPS, this interface is used. If not, SCSI inter-
face is used.
(2) [SCSI] is blinking:
SCSI interface is used. The interface on TPS is disre-
garded.
(3) [TPS] is blinking:
TPS interface is used. The SCSI interface is disregarded.
2
2
n
c
I
!
t
e
=
u
t
o
A
S
C
S
/
I
T
P
S
f
a
r
e
/