FujiFilm 4500N - Manual (Page 33)

24
3.1 Connecting Other Devices
CAUTION
● Before connecting other devices, turn all the power switches
OFF ( ).
● Make connection to the network when the network setting
on PICTROGRAPHY 4500N has been completed.
Connect the machine to other devices using the Ethernet cable.
Ethernet interfaces that Pictography 4500N is compatible with
are as shown below.
● 10BASE-T (compatible in half duplex mode and full duplex
mode)
● 100BASE-TX (compatible in half duplex mode and full duplex
mode)
For Ethernet cable, prepare twisted pair cable that matches
the connection form of the network used.
Note: ● In case of 100BASE-TX, category 5 cable is required.
● When connecting directly to PC, prepare a cross cable.
1 . Connect the Ethernet cable prepared to the interface
connector.
2 . Connect the other end of the Ethernet cable to hub, router
or Ethernet connector of PC (when connecting PC directly).
● Be sure to use a straight cable to connect to hub, router.
● When connecting to PC directly, be sure to use a cross
cable.