FujiFilm 4500N - Manual (Page 97)

88
8 . Align the new water filter notch with the holder partition
and place the new water filter into position.
NOTE: Rotate the water filter in both directions to make sure that it is
secured firmly. If the water filter moves, reinsert it, making
sure the notch and partition are correctly aligned.
9 . Align the water filter cover with the holder and rotate
clockwise to secure it.
10. Close the front upper door.
★ The water pump starts supplying the water coating
section with water.
IMPORTANT:
If the " " LED lamp on the transfer monitor comes on,
make sure that the water filter cover is secured firmly.
NOTE: After replacing the water filter, it takes about two minutes before
printing is enabled.
5.3 Water Filter Replacement
Holder Partition
Water Filter Notch