FujiFilm 4500N - Manual (Page 42)

33
3
OPERA
TING PR
OCDURES
3 . Remove the core of the receiver magazine and adjust the
partitions to the receiver being used. The size of the receiver
must correspond to the donor as shown below.
Size of receiver Corresponding donor size
315 mm (Double Letter Wide,etc.) 323mm
279 mm (Double Letter and Letter) 305mm
254 mm (10 x 12 and 10 x 8) 262mm
127 mm (5R,etc.) 135mm
102 mm (4R,etc.) 135mm
NOTE: Use the proper combination of donor and receiver. Do not use
combinations other than those above. If you do, the message
"Warning Check Magazine Type" appears.
4 . Take out the receiver magazine from the casing and inner
bag. Take the roll of the new receiver and insert the plastic
flanges into the right-hand and left-hand sides of the roll.
5 . Pull out the leading edge of the receiver about 0.8 in. (2
cm) and insert it into the receiver replacement magazine.
Then close the cover and lock both sides firmly.
6 . Specify the type of receiver being used with the dip switch
on the receiver magazine.
1 2 3 OFF
ON
Type 1 2 3 4
Standard thickness, glossy, SG
↓ ↑ ↑ ↑
Thin glossy, LG
↑ ↓ ↑ ↑
Standard thickness, matte, SM
↓ ↑ ↓ ↑
Thin matte, LM
↑ ↓ ↓ ↑
3.5 Receiver Magazine Replacement
Partitions
315mm
297mm
254mm
127mm
102mm
0.8 in.
(2 cm)
Dip Switch