Freedom9 4020 - Manual (Page 110)

103
local disk, you will not be able to connect to the freeStor 4020. Likewise, when you boot
remotely, you will not be able to recover your disks at all. This problem can also occur if you
change the recovery password between backups using DiskSafe Express and then remotely
boot from one of the earlier backups. In this case as well, the recovery password in the
Microsoft iSCSI Initiator will not match the recovery password on the freeStor 4020.
To address this issue, you must reconfigure the Microsoft iSCSI Initiator to use the password
that you specified on the freeStor 4020. If you’re using the recovery CD, you must do this after
you recover your system disk. If you’re booting remotely, you must do this while in Network Boot
Mode (before you recover your system disk) and again after you recover your disk and boot
locally.
To reset the recovery password in the Microsoft iSCSI initiator:
1. Click Start Æ Programs Æ Microsoft iSCSI Initiator Æ Microsoft iSCSI Initiator.
2. Click the “Targets” tab.
3. If more than one target appears in the Targets list, select the one that contains the name of
the freeStor 4020.
The Status should be Disconnected.
4. Click “Log On”.
5. Click “Advanced”.
6. Select the CHAP logon information check box.
7. In the User name text box, type your computer name in all capital letters.
8. In the Target secret text box, type the recovery password that you specified on the storage
system.
9. Click “OK” on the Advanced Settings and Log On to Target dialog boxes.
The Status of the target should now be Connected.
10. Click “OK” on the iSCSI Initiator Properties dialog box.