Freedom9 4020 - Manual (Page 75)

freeStor 4020 User’s Manual
68
4. Click “OK”.
5. When the confirmation message appears, click “OK”.
If your computer has an Internet connection, the license is activated automatically. If your
Internet connection is temporarily down, your license will be activated automatically the next
time you run DiskSafe Express with a restored Internet connection. If this computer does not
have an Internet connection, you must perform offline activation (as described in the previous
section).
4.2.6 Protecting Your Disks
After you install DiskSafe Express and restart your computer, the Protect a Disk wizard runs
automatically. Using this wizard, you can specify which disk or partition you want to back up,
where the backups should be stored, when automatic backups (if any) should occur, and what
password you want to use for the recovery CD. If you cancel this wizard, you can start it again at
any time using the following procedure.
To protect a disk:
1. Click “Protect a Disk” to run the Protect a Disk wizard.
2. In the Available disks list (Figure 4-8), select the disk or partition that you want to protect.
Figure 4-8: DiskSafe Express Disk Selection
If your computer has only one hard disk, there will still be two items in this list. The first item
represents the entire hard disk, and the second item represents the partition on that disk. (If
there’s only one partition on the disk, the partition is the same as the entire disk.)