Freedom9 4020 - Manual (Page 72)

65
later” and then click “Finish”. You do not have to restart the computer immediately after
installation, but you do have to restart it before running DiskSafe Express.
Note: If you do not restart your computer and you subsequently reinstall
DiskSafe Express, serious problems can occur with your installation. It is strongly
recommended that you restart your computer at your earliest convenience.
17. After you restart the computer, the License dialog box appears (Figure 4-6).
Figure 4-6: DiskSafe Express License Dialog
18. Type the key code for licensing the product and click “OK”. If your computer has an Internet
connection, the license is activated automatically. When you click OK on the confirmation
message, the Protect a Disk wizard starts. For information about this wizard, refer to Section
4.2.6.
Note: If you previously used this key code on a different computer, an error
message will appear and you must re-activate your license. For more
information, refer to Section 4.2.5. If your Internet connection is temporarily
down, or if this computer doesn’t have an Internet connection, click “OK” on the
warning message. The Protect a Disk wizard still starts, but after 30 days you will
no longer be able to perform backups or recovery until you activate the license.
For more information, refer to Section 4.2.5.
4.2.4 Starting DiskSafe Express
To start DiskSafe Express, click Start Æ Programs Æ DiskSafe Express.
If you did not protect a disk after installing DiskSafe Express and restarting your computer, you
will be prompted to do so the first time you run this application. For information about this
wizard, refer to Section 4.2.6.