Garland MP-GD-10-S - Manual (Page 17)

Part # MPSM07 (03/24/08) Page 17
OPERATING INSTRUCTIONS, (Standard Models)
In Off Mode
When the oven is off, there are no lights or indicators . The
oven interior light will operate .
Start Up
Press the Cook/Off/Cool Down rocker switch to the COOK
position . The green lamp will light indicating the oven is
powered in cook mode .
The oven will begin to heat to the temperature set on the
thermostat dial . The amber lamp will light indicating the heat
is active . As the heat cycles on and off to maintain the set
temperature this light will go on and off accordingly .
Garland “safe door” feature will be operational . The door must
be closed tightly for the oven to operate in cook mode .
Fan Speed
The fan speed can be either high, (1725 RPM), or low, (1140
RPM) . The fan speed is controlled by the left rocker switch
positions marked HI and LO .
Interior Light
The oven interior light is activated by pressing the light
switch . This is a momentary switch . The light will stay lit as
long as this button is held in the on position . The light will
operate in any mode, whenever there is electrical power
connected to the oven .
Cool Down
Pressing the Cook/Off/CoolDown rocker switch to the
COOLDOWN position activates the fan and motor to cool the
oven cavity . The door must be open slightly for the fan and
motor to start . Heat is not active in this mode .
Optimal cool down will be achieved with the door open
slightly .If the door is opened too wide the motor and fan
will shut off . This is a safety feature . When the door is partially
closed again the motor and fan will operate .
Cool down will continue to operate until the control is
changed . Pressing the rocker switch to the OFF position
cancels Cool Down and turns the oven off .
Temperature
The temperature range is from 150°F, (66°C), to 500°F, (250°C) .
Temperature is controlled by aligning the indicator to the
desired temperature .
Timer
The timer is set by rotating the dial clockwise, aligning the
indicator to the desired time cycle . The timer will count down
from 3 minutes to 1 hour . At the end of the timing cycle, a
buzzer will sound . The buzzer is turned off by rotating the dial
counterclockwise to the OFF position .
Moisture Control
When the Moisture Switch is set to AUTO, moisture will be
injected at the rate set by the moisture control . Rotate the
dial counterclockwise to decrease moisture . Rotate the dial
clockwise to increase moisture .
Moisture Switch
This is a three-position switch to control how the moisture
is injected into the oven; manually, not at all (off), or
automatically . The OFF and AUTO settings are fixed . The MAN,
(manual), position is momentary . This momentary actuator
injects water when pressed . It is strongly recommended that
moisture only be injected manually by holding the button for
one second at a time .
NOTE: Water can only be injected after the oven has
preheated to at least 225°F (107°C)