Garland MP-GD-10-S - Manual (Page 58)

Part # MPSM07 (03/24/08) Page 58
8 . Test door switch activation / operation as indicated in the
diagnostic checks .
9 . If the door switch assembly requires adjustment, position
the door to the full close position . Loosen the assembly
mount screws just enough to set the switch stricker arm
rollers at a position where there is no pressure on the rollers
at either cam surface .
10 . At that point, tighten the switch assembly bracket screws .
11 . Run the door position diagnostic check again .
Oven Temperature Probe Service/Removal
The probe is located on the interior RIGHT rear side of the
oven cavity .
1 . To first gain access to the temperature probe, remove the
oven racks, rack support guides and bafflle plate . Remove
the 2 screws holding the probe in place . DO NOT REMOVE
THE PROBE at this point .
2 . Remove the 2 screws holding the probe in place .
3 . DO NOT REMOVE THE PROBE at this point .
Note: The wires for the probe are located behind the RIGHT
side panel .
SERVICE PROCEDURES (REMOVAL/REPLACEMENT)
6 . Use a clean dry cloth to hold the new light, DO NOT
TOUCH NEW LIGHT WITH YOUR FINGERS .
7 . Install the replacement light .
8 . To reassemble, reverse above instructions. Ensure that the
cavity light wires on the RIGHT side of the oven are re-
connected
Door Micro Switch Service / Removal /
Replacement And Adjustment
Note: Disconnect electrical power from the oven .
1 Open the oven door .
2 . Locate and remove the 2 machine screws located in the
upper LEFT side of the cavity frame . (These screws are just
RIGHT of the upper door post on the cavity door frame .)
Door Switch
adjustment
screws
3 Remove both screws . DO NOT TOUCH THE COUNTERSINK
SCREW .
4 . Remove the 2 screws holding the door micro switch cover .
This is located on the front LH side of the oven top panel .
5 . Upper switch on bracket is SW2, lower switch is SW1 .
6 Replace required micro switch .
7 . Reinstall door switches and bracket and screws .