Garland MP-GD-10-S - Manual (Page 9)

Part # MPSM07 (03/24/08) Page 9
PREPARING THE OVEN FOR INSTALLATION
Open Base Assembly
Use the following sequence of steps to assemble and install
the open base accessory .
1 . (See Figure 2 .) . Align the rack guide upper support to the
corresponding holes in the oven base . Fasten using three
#10 x 3/4” machine screws on each side of the oven .
2 . At the lower end of each leg install an “L” shaped support
clip using a #10 x 3/4” sheet metal screw . Do this before
fastening the leg to the base .
3 . Install legs to the bolt holes at the front and rear of the
base on the oven’s left side, (side lying on the floor) . If
installing casters, be sure to install a locking caster on the
front leg . Refer to the section, “Legs and Casters,” on the
previous page for installation details .
4 . Fasten the open base panel in place on the brackets of
the two legs already installed, using one #10 x 3/4” sheet
metal screw in each corner .
5 . While supporting the open base panel, install the right-
side legs as in step 2 . Ensure the caster with a brake is at
the front of the oven . Fasten the remaining two corners of
the open base panel to the other two legs just installed .
6 . Carefully return the oven to an upright position . Ensure
the two legs/casters that touch the floor first when you
raise the oven are blocked and chocked so they do not slip
away .
7 . Install the rack guides in one of the two available
positions . The inner position sets the guides at a width
to accommodate oven pans . The outer position sets the
guides at a width to accommodate wire oven racks . To
attach, insert the longer straight end at the top of the rack
guide all the way into the mounting hole, then align the
bottom holes and lower the rack guide into position .
8 . It is very important to use the adjustable bullet foot
inserts in leveling the unit.
9 . If you have installed casters, be sure to install the restraint
bracket on the lower left corner of the rear of the oven
using two #10 x 3/4” sheet metal screws .
Figure 2.
RACK GUIDE UPPER SUPPORT
RACK GUIDE (2)
INNER GUIDE POSITION
FOR TRAYS
OUTER GUIDE POSITION
FOR RACKS
OPEN BASE PANEL
SCREW (6x)
LEG ASSEMBLY (4)
W/FOOT INSERT
OPEN BASE UPPORT CLIP (4)
SCREW (1 EACH CLIP)
SCRREW (2 EACH CLIP) INNER
OUTER