GE GFK-2489 - Manual (Page 118)

5-4 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489
5
Point-to-Point, Serial-to-Serial Application Example
Once the transceivers are configured and the changes have been executed, they begin
processing any data presented at the COM ports. Data presented at the AP COM port is
packetized and sent over the air via a proprietary protocol to the Remote. Upon receiving the
packet, the Remote sends the data from its COM port. Likewise, data presented at the
Remote COM port is packetized, sent to the AP, stripped, and sent from the AP COM port.
Note that this configuration does not use multi-cast addressing.
Use the Serial Configuration Wizard (Local Serial Configuration menu) to make the settings
listed in the table below. Following the table are step-by-step screen images of the Wizard.
Point-to-Point Serial-to-Serial Configuration
TS Wireless Menu Item Setting
radio Location
AP (COM2)
Port Status Enabled
Mode Serial-to-Serial
Remote UnitID 1155999 (example)
Rem. COM Port COM2
Baud Rate 19200 Byte
Format 8N1
Buffer Size 256 Bytes
Inter-Packet Delay 4
Remote radio (COM2) Mode Data
Baud 19200
Format 8N1
Buffer 256
DelayChars 4