GE GFK-2489 - Manual (Page 49)

3-16 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489
3
Mobility Configuration Menu
Mobility Configuration Menu
A) BSP Routing Enable disabled
B) IAPP Enable disabled
C) Unit Update Enable enabled
D) IAPP Multicast Address 244.254.1.1
E) IAPP Multicast Port 39990
F) IAPP Multicast TTL 1
G) IAPP Unicast Port 39990
Select a letter to configure an item, <ESC> for the prev menu
▪ BSP Routing Enable
—This parameter controls intra-cell transmission and routing of
Basic Serial Protocol packets.[Enabled, Disabled; Disabled]
▪ IAPP Enable —This parameter enables the Inter-Access Point Protocol (IAPP), which
allows APs to pass payload data over the Ethernet LAN. [Enabled, Disabled; Disabled]
▪ Unit Update Enable
—This parameter allows the AP to immediately send out an IAPP
update when a Remote connects or disconnects. [Enabled, Disabled; Disabled]
▪ IAPP Multicast Address —An address that allows multicast messaging to travel to all
radios in a subnetwork (all radios with a common network address). [224.254.1.1]
▪ IAPP Multicast Port —An assigned software port that allows mul-ticast messaging to
travel to all radios in a subnetwork (all radios with a common network address). [39990]
▪ IAPP Multicast TTL —Multicast “time to live” number. This is the number of hops that a
message is allowed to make before it is no longer transportable. This feature prevents
“infinite life” packets that degrade system performance. [1-15; 1]
▪ IAPP Unicast Port —An address that allows messaging to travel to a specific radio when
that message has originated from another subnetwork. [39990]