GE GFK-2489 - Manual (Page 19)

GFK-2489 Chapter 1 Introduction 1-13
1
ETSI Installations: In regions where the European Telecommunications Standards Institute
(ETSI) standards apply, 2.4 GHz units with a maximum output power of 100 mW EIRP are
supplied. Do not allow people to come closer than 2.2 cm (1 inch) to the antenna.
CSA/US Notice
The transceiver has been recognized for use in hazardous locations by the
Canadian Standards Association (CSA), which also issues the U.S. mark of
approval. The CSA Certification is in accordance with CSA STD C22.2 No. 213-
M1987.
FCC Part 15 Notice
The transceiver complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device is specifically designed to be used under Section 15.247 of the FCC Rules and
Regulations. Any unauthorized modification or changes to this device without the express
approval of GE Fanuc may void the user’s authority to operate this device. Furthermore, this
device is intended to be used only when installed in accordance with the instructions outlined
in this manual. Failure to comply with these instructions may also void the user’s authority to
operate this device.
Environmental Information
The manufacture of this equipment has required the extraction and use of natural
resources. Improper disposal may contaminate the environment and present a
health risk due to hazardous substances contained within. To avoid dissemination
of these substances into our environment, and to limit the demand on natural resources, we
encourage you to use the appropriate recycling systems for disposal. These systems will
reuse or recycle most of the materials found in this equipment in a sound way. Please contact
GE Fanuc or your supplier for more information on the proper disposal of this equipment.