GE GFK-2489 - Manual (Page 33)

2-12 TranSphere TS Wireless Extended Range IP Networking Transceivers – January 2008 GFK-2489
2
Verify Connectivity (PING command)
If the radio LEDs indicate that the radio network is operating properly, you can use the PING
command from the AP to verify the link integrity between the AP and an endpoint device
connected to the Remote radio. The following illustration shows the typical arrangement for
this test.
To conduct a PING test, an Ethernet-enabled device must be connected to the Remote, and it
must have a compatible IP address. Remote radios do not have an IP address and cannot be
verified directly using this method.
Serial Connections
To check a serial connection, refer to Local Serial Configuration Menu. This section contains
details on establishing an IP-to-serial or serial-to-serial connection.