Removing the printer from the shipping box, Removing additional packing, Removing packing – GCC Printers Elite 12ppm User Manual

Page 13: Remove the tape from the printer’s top cover, Elite

Advertising
background image

1-6

Removing the printer from the shipping box

Warning: The printer weighs about 30 pounds (about 14 kilograms).

Note: Save the packing materials inside the shipping box and put the box in a safe place;
you will be able to repack the printer should you need to move it again.

1. Take the printer out of the of the box and remove the packing material.

2. Take the printer out of the plastic bag.

3. Take the documentation and CD-ROM out of the plastic bag.

4. Check that you have all of the following:

GCC

T

ECHNOLOGIES

Elite

12ppm

Configuration Page

Printer Information

Interfaces

Paper Handling

Language: English
AppleTalk Name: Model
Page Count: 20
RAM Installed: 8MB
Hard disk: No disk
OS Version: 2.3
PostScript Level 2 Version: 2.3
ROM Version: 2.3
H/W Version: 1.0
AccuGray: Enabled

Print Darkness: Normal
Default Source: Upper Tray
Default Size: Letter
Jam Recovery: Disabled
Paper Reserve: Enabled
Manual Feed Timeoutt: 5 Minutes

8-pin Serial: LocalTalk

RS422 Serial (Inactive)

Baude Rate: 9600
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: Xon/Xoff

RS232 Serial (Active)

Baude Rate: 9600
Data Bits: 8
Stop Bits: 1
Parity: None
Flow Control: Xon/Xoff

Parallel Port (Active)

PS/PCL Sensing: PostScript Only

Port Emulation

Parallel Port: Auto Switch
RS232 Port: Auto Switch
RS422 Port: Auto Switch
LocalTalk Port: PostScript Only

PostScript

Default Resolution: 800
Job Cancel: Enabled
Start Page: Disabled
Wait Timeout: 300 Seconds

PCL

Resolution: 600
Copies: 1
Font Source: Internal
Font Number: 1
Pitch: 10.0
Point Size: 12.0
Orientation: Portrait
Page Length: 60
Symbol Set: Roman-8
Wait Timeout: 120 Seconds
Line Wrap: Disabled
Line Termination: Normal

Emulations

Configuration page

Toner cartridge

(in box)

Installation guide

Elite 12ppm CD-ROM

Universal paper tray

AC power cord

Elite

12ppm

I N S TA L L AT I O N G U I D E

If any of these items are missing, contact your dealer or GCC Technical Support (781-276-
8620) immediately.

You will need to provide a cable to connect your computer or network to the printer.

Warning: If you use the parallel port interface, the cable you use must be suitable for
bi-directional transmission (IEEE 1284). Standard (unidirectional) parallel cables can
cause errors in printing.

Removing additional packing

1. Remove the tape from the printer’s top cover.

Advertising