GCC Printers Elite 12ppm - Manual (Page 141)

C-2
GCC strongly recommends that you use a grounding wrist strap. You can buy one from
the same place that you bought your SIMMs. If you do not have a grounding wrist strap,
touch the perforated metal chassis of the printer (see step 9 following).
Installing the RAM into the Elite
12ppm
1. Switch off the printer. Do not
unplug the power cord from
the AC outlet.
2. Unplug the interface cables
from the back of the printer.
3. If necessary, move the printer so
that you have clear access to its
left side.
4. Remove the paper tray.
5. Open the top cover by pressing the
release button on the top right of the printer.
6. You need to remove the side cover. Unscrew
the two thumbscrews at the rear of the
printer (labelled “A” in the bottom picture).
If these are tight, you may need to use a #2
Phillips screwdriver.
7. Reach inside the case. Pull the
edge of the cover (B) toward
you, then move the cover
away from the rest of the
printer to prevent it from
latching again.
8. Place both hands on the top
of the side cover (C). Lift the
edge of the cover next to
the top cover; this unlatches
the cover, and you should
be able to slide the cover
away from the printer.
A
A
C
B
B
C