GCC Printers Elite 12ppm - Manual (Page 34)

2-10
either Pitch: The number of characters per
horizontal inch for the default font.
or Point Size: The point size of the default
font.
Orientation: The default alignment of the
image on the page.
Page Length: The default number of lines
on the page.
Symbol Set: The set of character symbols
the default font uses.
Wait Timeout: How long the printer waits
for more input after printing all the input
received (but without receiving a message
saying that the job is complete).
Line Wrap: For “plain text” print jobs,
whether the text at the end of a line will end at
the margin and continue onto the next line, or
whether the line of text will be cut off at the
margin.
Line Termination: For “plain text” print
jobs, sets carriage return and line feed (form
feed) commands to determine which is the
end-of-line indicator.
From 0.44 to 99.99 in 0.25
increments. Default is 10.00.
From 4.00 to 99.75 in 0.25
increments. Default is 12.00.
Portrait or Landscape
From 5 to 256. The default is 60
for letter size paper.
The character symbols the font
supports (see notes). Default is
Roman-8.
From 45 to 120 seconds in 15-
second increments, or Never
Timeout.
Disabled or Enabled.
Normal, CR=CRLF, LF=CRLF
and FF=CRFF, or ALL.
This submenu only appears if the default font
uses fixed spacing (monospaced).
This submenu only appears if the default font is
scalable and is proportionally spaced.
This setting may change if the settings in the
Default Size submenu of the Paper Handling
menu are set to a size other than the factory
default.
See the Fonts section of this CD-ROM for a list
of the symbol sets for resident PCL fonts.
Some applications may change this setting
during the printing process. In some cases the
change will be permanent and the new timeout
setting will appear in the display. You can reset
it, or, if the application is one you use fre-
quently, leave the new setting.
Emulations (continued)