GCC Printers Elite 12ppm - Manual (Page 190)

K-4
FEDERAL COMMUNICATIONS COMMISSION
WARNING: This equipment was tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions in this manual, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. For more information about radio frequency interference, refer to the section of this manual on
Radio and TV interference.
CANADIAN REGULATIONS
This equipment is a Class A digital apparatus that complies with the Radio Interference Regulations, CRC c.
1374.
IMPORTANT: Changes or modifications to this product not authorized by GCC Technologies Inc. could void
the FCC Certification and negate your authority to operate the product. This product was tested for FCC
Compliance under conditions that included the use of shielded cables and connectors between system
components. It is important that you use shielded cables and connectors to reduce the possibility of causing
interference to radios, television sets, and other electronic devices. You can obtain the proper shielded cables
from GCC Technologies or from an Authorized GCC Technologies dealer.
CLASS 1 LASER PRODUCT
LASER SAFETY: This printer is certified as a Class 1 laser product under the U.S. Department of Health and
Human Services (DHHS) Radiation Performance Standard according to the Radiation Control for Health and
Safety Act of 1968. This means that the printer does not emit hazardous radiation. Since radiation emitted
inside the printer is completely confined within protective housings and external covers, the laser beam
cannot escape from the machine during any phase of user operation. The Center for Devices and Radiological
Health (CDRH) of the U.S. Food and Drug Administration implemented regulations for laser products on
August 1, 1976. These regulations apply to laser products marketed in the United States. The label on the
printer indicates compliance with the CDRH regulations and must be attached to the laser products marketed
in the United States.
Caution - Use of controls, adjustments, or performance of procedures other than those
specified in this manual may result in hazardous radiation exposure.
EPA ENERGY STAR COMPUTERS AWARD
The Elite 12ppm printer is designed to conserve electricity. With
its power-saving design, the Elite 12ppm qualifies for the U.S.
Environmental Protection Energy Star Computers Award.
CREDITS
© Copyright GCC Technologies Inc., 1998. All rights reserved.
The Elite 12ppm User Manual was written by David Field.
It was edited by Saadia Baloch, Lee Doron, Armik Ghazarians, Brian Harriss, Krista Ingram, Bill
Krech, Rebecca Leebow, Michael McCabe, and David Nicholson.
Cover design and illustrations by Bill Krech.
Fonts used were Frutiger and Minion. Printed in USA; part number 030.16403 rev B.