GCC Printers Elite 12ppm - Manual (Page 152)

D-5
4. Roll the postcard guide toward you by pulling it forward. It will become free at
the rear. Now you can slide it up and back to remove the two tabs from the
slots and remove it from the envelope tray.
5. Move the postcard guide to the right rear of the envelope tray. This is where
it’s stored when you’re not using it.
6. Tilt the back of the postcard guide up and toward you so that the two tabs fit
in the two slots.
7. Place your forefingers under the tab at the front of the postcard guide, and
press down on the top center of the guide with your thumb.
8. Rotate the postcard guide away from you so that it lies flat in the envelope
tray. It will click into place.
9. If the guides are set to the envelope size you intend to use, go to step 11.
10. Lift the rear of the size guide and move it back or forward so that it fits the size
of the envelopes you’re using.
The holes in the size guide fit over a pair of tabs in the bottom of the envelope
tray. The holes must fit over the tabs. The size guide has the names of envelope
sizes by the holes.
11. Squeeze the width guide lever toward its brace, and then pull the guide lever
to the right.