Interfaces – GCC Printers Elite 12ppm User Manual

Page 35

Advertising
background image

2-11

Submenu

8-pin serial

RS422 Serial
(5 submenus)

RS422 Baud Rate: The RS422 baud rate.

RS422 Data Bits: The number of data bits
sent with each serial byte.

RS422 Stop Bits: The number of stop bits
sent with each serial byte.

RS422 Parity: The parity sent with each
serial byte.

RS422 Flow Control: Which flow control
is used by the RS422 serial port.

Settings

LocalTalk or RS422

300, 600, 1800, 2400, 3600, 4800,
7200, 9600, 19200, 38400, or
57600.

8 or 7

1, 1.5, or 2

None, Even, or Odd

XON/XOFF, XON/XOFF Input,
or DTR

Notes

If you change the 8-pin serial setting, you must
restart the printer.

The RS422 menu only appears when you choose
the RS422 option in the 8-pin serial menu.

Always set this to DTR when you send a PCL
job.

7. Interfaces –

press the Enter key to access the submenus. The Interfaces submenus also

have submenus.

TCP/IP: Whether print jobs will be accepted
over a TCP/IP network.

There are twelve other submenus in the TCP/IP
menu system; you will need to configure these
to run TCP/IP. Full details of the menus and
their recommended settings are in the TCP/IP
section of the networking guide on this CD-
ROM.

NEST (1200 dpi model only): Allows you
to configure the printer on a Novell network
without needing to use a computer as a print
server.

Frame Type: The Frame Type of printers on
the Novell network.

Enabled or Disabled.

Enabled or Disabled.

802.2, 802.3, Ethernet II, or
SNAP.

TCP/IP will not be operational until you have
configured the settings in the TCP/IP submenus.
Until then, setting this switch to Enabled has no
effect. When TCP/IP is configured, this menu will
allow you to turn it on and off. For full details, see
the TCP/IP section of the networking guide on
this CD-ROM.

If the Frame Type differs from what you specified
in the NEST software, the printer will not be
available to the network.

Advertising