GCC Printers Elite 12ppm - Manual (Page 133)

A-3
Envelopes
Commercial #10: 4.125 x 9.5 (104.8 x 241.3 mm)
Monarch: 3.875 x 7.5 (98.4 x 190.5 mm)
DL: 4.33 x 8.66 in. (110 x 220 mm)
C5: 162 x 229 mm (6.38 x 9.02 in.)
Print alignment
Skew: The amount by which a supposedly horizontal printed line may vary from being
parallel with the edge of the paper. This assumes that vertical printed lines are also at an
angle, so that the entire image is printed correctly but slightly rotated on the page. Mea-
sured with a 190 mm (7.48 inch) line.
Within 1.2 mm (0.047 inch) either up or down (normal paper tray)
Within 1.4 mm (0.055 inch) either up or down (multipurpose tray)
Registration: The amount by which images appearing to left or right, or above or below
previously printed images. Images appear on the paper correctly printed and aligned, but
not in the same place. Measured at the mid-point of the side or top of the paper.
Within 2.0 mm (0.079 inch) horizontal or vertical either way
Magnification: The amount by which a line can be greater or smaller than its nominal
length. Measured with a 240 mm (9.45 inch) vertical line and a 190 mm (7.48 inch) hori-
zontal line. These lines are centered on the page to avoid measuring parallelism errors.
Within 0.8 percent longer or shorter than its nominal length
Parallelism: The amount by which the ends of two vertical and two horizontal lines can
be greater or farther apart than the other ends. Measured with vertical lines of 234 mm
(9.21 inch) and horizontal lines 190 mm (7.48 inch). These lines are arranged to form a
rectangle on the page.
Within 1.44 mm (0.057 inch) horizontal or vertical either way
Linearity: The amount that three straight lines (horizontal, vertical, and diagonal) can
vary from being truly straight. One end of each of the horizontal and vertical lines meet at a
corner; the diagonal line is at 45 degrees to the other two lines and passes close to the
center of the paper. The horizontal line is 190 mm (7.48 inch), the vertical line is 234 mm
(9.21 inch), and the diagonal line is 269 mm (10.6 inch). The amount is measured by the
distance a line can vary from the position of a true straight line.
Within 0.5 mm (0.02 inch) either side, horizontal and vertical lines