Gateway ALR 9200 - Manual (Page 212)

200 Maintaining and Troubleshooting the Gateway ALR 9200 Server
drive
5.25-inch, installing 4
cabling considerations 48
CD-ROM activity light does not
light 168
controllers and connectors 12
fans, high-power SCSI hard
drives 57
floppy drive A field 85
floppy drive B field 85
hard disk activity light does not
light 168
hard drive input LED connector 14
heatsinks on high-power SCSI hard
drives 54
IDE, cabling 49
installing a 5.25-inch drive 49
installing the diskette drive 47
removing a 5.25-inch drive 52
removing the diskette drive 45
replacing the diskette drive 47
SCSI
cabling 49
drive error LEDs 56
hot-swapping 56
mounting in carrier 55
drivers, video, installing 77
dual in-line memory module
see DIMM
dynamic random access memory
see DRAM
E
ECC, memory type 10
editing resources in the SSU 115
EDO, memory type 10
electromagnetic compatibility
see EMC
electromagnetic interference
see EMI
electronics bay
closing 7
defined 5
opening 5
EMC
compatibility 190
compliance with standards 194
emergency management port
see EMP
EMI shield, removing 50
EMP Console
Baud Rate 134
Client Configuration 132
COM Port Address 134
command state 130
connect to remote server 137
console redirection menu 134
Console Type 134
Direct Connect Configuration 133
EMP Access Modes 134
EMP Direct Connect/Modem
Mode 134
EMP Password 133
EMP Restricted Mode Access 134
Flow Control 134
FRU Viewer 144
FRU Viewer options 144
how it works 130
introduction 129
main menu 136
main window 134
management plug-ins 141
Modem Configuration 133
phonebook 140
power on/off remote server 138
redirect state 131
requirements 132
reset remote server 139
SDR Viewer 143
SDR Viewer options 143
SEL Viewer 141
SEL Viewer options 142
Server Configuration 133
server control operations 136
setting up the server 133
status bar 135
3424.boo Page 200 Wednesday, September 2, 1998 9:23 AM