Gateway ALR 9200 - Manual (Page 47)

Replacing the Processor 35
12. With the tabs at the top of the SEC cartridge completely open (pulled
outward, away from the center of the cartridge—C in Figure 7), slide
the cartridge into the guide rails of the retention module (B in
Figure 7). When done properly, the triangular ends of the tabs (with
two round pegs on each) fit into the entrance to the guide rails.
Figure 7: Installing a Processor
13. When the cartridge meets resistance, push the two tabs toward each
other (E in Figure 7) until the processor is fully seated.
14. Reattach the retention module bracket:
a. With the bracket in an open position (perpendicular to the front of
the retention module), slide the open hinge at the left of the bracket
into its receptacle at the left of the retention module.
b. Rotate the bracket to the right until it reaches the retention module.
With your right thumb on the face of the bracket and your right index
finger around the tab at the right of the bracket, slightly pull the tab
outward and to the left to open the latch at the back of the tab.
c. As you open the latch on the back of the tab, slide the right edge of
the bracket onto the retention module and release the tab. If done
correctly, the bracket will latch securely.
SEC cartridge
Processor heat sink (must face away
from the center of the system board
Tab on SEC cartridge
Retention module guide rails
3424.boo Page 35 Wednesday, September 2, 1998 9:23 AM