Gateway ALR 9200 User Manual
Page 65
Installing Hardware 53
6.
The drive has two protruding plastic, snap-in rails attached. Squeeze
the rail tabs toward each other as you carefully slide the drive forward
out of the bay, and place it on an antistatic surface (Figure 18).
Figure 18: Removing a Removable Media Device
7.
Remove and save the four screws and two slide rails.
8.
If you do not replace the device with another 5.25-inch device, replace
the EMI shields to maintain the EMI and airflow characteristics of the
chassis.
If the device is a SCSI device and it was installed at the end of the
SCSI signal cable, modify the cable and termination arrangement so
that a proper termination exists at the end of the cable (it can be a
termination device only, not necessarily a SCSI peripheral).
9.
Close the subchassis and make sure the foam cover is properly
installed, being careful not to pinch any wires or cables (see “Closing
the Subchassis and Electronics Bay” on page 7).
Tab on slide rail
Removable media device
Slide rail
3424.boo Page 53 Wednesday, September 2, 1998 9:23 AM