Gateway ALR 9200 User Manual
Page 73
Installing Hardware 61
5.
Label and disconnect the desired fan cable from the front panel board.
Be sure to note the position of the cable where it is held in place in the
foam fan assembly (see Figure 25).
Figure 25: Fan Cabling
6.
Remove the fan cable from the foam assembly, being careful not to
break the foam.
7.
Remove the fan from the foam assembly. All systems fans sit
differently in the assembly, but in general, each fan can slide in and out
of the foam in only one way.
1
3
5
7
2
4
6
8
1
1
7
5
3
2
4
6
8
Note:
The two installed fans
nearest the 5.25-inch drive
bays (fans 6 and 7 in
Figure 25) are separated by
a square piece of foam (the
piece with a crescent-
shaped hole) that extends
perpendicularly from the
front of the fans (in
Figure 25, it is the rectangle
between the round faces of
fans 6 and 7). You must
remove this piece to access
the two fans it separates
(pull it straight out).
3424.boo Page 61 Wednesday, September 2, 1998 9:23 AM