Gateway ALR 9200 - Manual (Page 26)

14 Maintaining and Troubleshooting the Gateway ALR 9200 Server
Password Clear Jumper
Momentarily setting this jumper allows you to clear the passwords. The
normal jumper position protects the passwords. Use this jumper only if you
have forgotten the passwords and cannot access the system. This jumper
occupies pins 5-7 of the connector. See “Setting the Jumpers” on page 72
for more information on setting the password clear jumper.
Recovery Boot Jumper
The recovery boot jumper should be used only in the event of a failed BIOS
update. If you attempt a BIOS update and the update fails, set this jumper
and reboot the system. The system attempts to recover the previous version
of the BIOS as it boots up. This jumper occupies pins 9-11 of the connector.
See “Setting the Jumpers” on page 72 for more information on setting the
recovery boot jumper.
Miscellaneous Connectors
Hard Drive Input LED Connector (C)
This connector allows you to connect a cable from an add-in hard disk
controller to the system board to allow the add-in controller to activate the
hard drive activity LED on the control panel.
System Speaker Connector (D)
Connects the internal speaker to the system board.
Wake-on-LAN Technology Connector (F)
The wake on local area network (LAN) technology connector allows you to
connect a magic packet-enabled LAN adapter to the system board to
support wake on LAN functionality. Wake on LAN functionality allows a
system in power conservation mode to be awakened by an incoming
message on the network.
3424.boo Page 14 Wednesday, September 2, 1998 9:23 AM