Matrox Electronic Systems II - Manual (Page 10)

10 Chapter 1: Introduction
Matrox Meteor-II boards
Matrox Meteor-II comes in four versions: Matrox Meteor-II
/Standard, Matrox Meteor-II /Multi-Channel, Matrox
Meteor-II /Digital, and Matrox Meteor-II /1394. Some of these
boards are available in different form factors, namely PCI,
CompactPCI, and PC/104-Plus. All boards and form factors
support real time image transfer to Host memory, and can be
programmed with the Matrox Imaging Library (MIL) or any of
its derivatives.
Matrox Meteor-II /Standard
Matrox Meteor-II /Standard is a standard monochrome and
color analog frame grabber. This board is available in a PCI,
PC/104-Plus, or CompactPCI (3U) form factor, all of which can
use a Matrox Meteor-II MJPEG module for compression and
decompression of monochrome and color images.
(4 Mbytes)
VMChannel (not available
on CompactPCI and
PC/104-Plus)
Gain Decoder
To DB-44
Connector for
PCI and Compact
PCI form factors
BNC Connector for
PCI and Compact
PCI form factors
To 30-pin male,
right-angle
connector for
PC/104-Plus
form factor
32
24
32
64
VID_IN2
VID_IN9
VID_IN1
VID_IN8
VID_IN3
VID_IN10
VID_IN4
VID_IN11
VID_IN5
VID_IN12
VID_IN6
VID_IN7
Low
Pass
Filter
VIA SGRAM
Opto-
coupler
Trigger
Not available on PC/104-Plus
form factor
Host 32-bit PCI bus
Not available on
CompactPCI
form factor
12:1
MUX
MJPEG
Module
(optional)
UART
RS-232
drivers &
receivers
RX
TX
/RTS
/CTS
Aux
2
2 {