Matrox Electronic Systems II - Manual (Page 30)

30 Chapter 2: Hardware installation
3. Check that you have an available PC/104-Plus connector on
the motherboard, or verify that your existing stack can
support another board.
4. If you have existing PC/104 boards in your computer,
remove them and stack them on the PC/104-Plus board.
PC/104 boards must be stacked last.
5. Remove the anchoring screws from the stack; do not discard
them since you will need them to fasten the Matrox
Meteor-II board.
6. Carefully position Matrox Meteor-II over the connectors
and press the board firmly into place.
7. Replace the anchoring screws.
8. Set the rotary switch (next to the PC/104 (ISA) connector)
to 0 if installing the first stackable module, or another
appropriate setting if not the first. See the section, Multiple
board installation, in Chapter 4.
9. Connect your video sources. For details, see the Connecting
external devices section.
Motherboard
PC/104-
(PCI) connector
Plus
PC/104
(ISA)connector
Rotary
switch
Video input
connector
Expansion
module
connectors