Matrox Electronic Systems II - Manual (Page 28)

28 Chapter 2: Hardware installation
4. Press the board firmly but carefully into the connector.
5. When the board is in place, the handle opens automatically,
exposing a screw. Tighten both this screw, and the one at
the top of the bracket.
6. Connect your video sources. For details, see the Connecting
external devices section.
7. Turn on your computer.
Under Windows 98, when you boot your computer,
Windows’ Plug-and-Play system will detect a new PCI card
and you will be asked to assign a driver to it. At this point,
you should click on Cancel because the driver will be
installed during the installation of MIL or one of its
derivatives.
Guide
CompactPCI
connector
Back plate
of subrack
Screw
Handle