Matrox Electronic Systems II - Manual (Page 107)

Board input and output connectors 107
VMChannel interface connector
The VMChannel interface allows Matrox Meteor-II to share
data with any Matrox imaging board that has a VMChannel
interface capable of performing the bus controller function. A
VMChannel backplane (available with the GEN-BUS/...
interconnect kits) must be inserted across the VMChannel
interfaces of the boards. For pinout information, see
VMChannel interface connector in Appendix B.
Jumpers
Each jumper connects a 100 termination resistor between the
two polarities of the following signals:
Jumper B1 - B2: TRIG+, TRIG-
Jumper B3 - B6: VSYNC+, VSYNC-
Jumper B4 - B5: HSYNC+, HSYNC-
Jumper B7 - B8: CLKIN+, CLKIN-
Ω
B3
B1
B4
B7
B2
B6
B5
B8
Jumper