Matrox Electronic Systems II - Manual (Page 54)

54 Chapter 5: Matrox Meteor-II hardware reference
Matrox Meteor-II hardware reference
This chapter provides information on the architecture,
operating modes, and supported features of the Matrox
Meteor-II boards.
For a summary of the information given in this chapter and
detailed specifications of connectors and pinouts, refer to
Appendices B, C, D, and E of this manual.
Matrox Meteor-II /Standard grab section
The grab section of the Matrox Meteor-II /Standard board uses
a video decoder to capture composite RS-170, CCIR, NTSC, and
PAL, and component (Y/C) NTSC and PAL.
.
(4 Mbytes)
VMChannel (not available
on CompactPCI and
PC/104-Plus)
Gain Decoder
To DB-44
Connector for
PCI and Compact
PCI form factors
BNC Connector for
PCI and Compact
PCI form factors
To 30-pin male,
right-angle
connector for
PC/104-Plus
form factor
32 24
32
64
VID_IN2
VID_IN9
VID_IN1
VID_IN8
VID_IN3
VID_IN10
VID_IN4
VID_IN11
VID_IN5
VID_IN12
VID_IN6
VID_IN7
Low
Pass
Filter
VIA SGRAM
Opto-
coupler
Trigger
Not available on PC/104-Plus
form factor
Host 32-bit PCI bus
Not available on
CompactPCI
form factor
12:1
MUX
MJPEG
Module
(optional)
UART
RS-232
drivers &
receivers
RX
TX
/RTS
/CTS
Aux 2
2 {