Matrox Electronic Systems II - Manual (Page 31)

Installing the Matrox Meteor-II MJPEG module 31
10. Turn on your computer.
Under Windows 98, when you boot your computer,
Windows’ Plug-and-Play system will detect a new PCI card
and you will be asked to assign a driver to it. At this point,
you should click on Cancel because the driver will be
installed during the installation of MIL or one of its
derivatives.
Installing the Matrox Meteor-II MJPEG
module
Matrox Meteor-II MJPEG module is available in two form
factors: one for use with PCI and CompactPCI form factors, and
one for use with the PC/104-Plus form factor. The module is
supported on Matrox Meteor-II /Standard and /Multi-Channel.
PCI and CompactPCI
form factors 1. Position the boards such that the male connector on the
module is aligned with the female connector on the base
board and the female connector on the module is aligned
with the male connector of the base board.
PCI connector
MJPEG module
Meteor-II board