Multi-Tech Systems ISIHP-2U - Manual (Page 12)

12 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD
Hardware Installation
Introduction
This section describes how to install the ISIHP server card into the
PCI bus on your personal computer, which involves
• Opening your PC
• Installing the card into the PC
Computer Requirements
• Pentium-based PC or compatible with PCI bus architecture
• Microsoft Windows 95, Windows 98, Windows NT version 4.0, SCO
Open Server version 5.0, Novell NetWare, or Linux
• At least one floppy drive
• 800 blocks of hard disk space for UNIX, 100K bytes for Windows
NT, 34K bytes for Windows 95, 50K bytes for Novell
Shipping Contents
• ISIHP card
• RJ-45 ISDN cords (2 for ISIHP-2S/2U; 4 for ISIHP-4S/4U)
• ISIHP Driver Disk set
• ISDN TA Configuration Wizard disk
• Quick Start Guide
• User Guide (this online manual) on CD-ROM
Safety Warnings
• Never install telephone wiring during a lightning storm.
• Never install telephone jacks in wet locations unless the jacks are
specifically designed for wet locations.
• Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than cordless type) during an
electrical storm. There may be a remote risk of electrical shock from
lightning.