Multi-Tech Systems ISIHP-2U - Manual (Page 49)

Software/Driver Installation (Windows 95/98)
MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD 49
Removing the Driver (Windows 95 only)
1. Click Settings, Control Panel, and then double-click Add/
Remove Programs.
2. From the list box, select ISICOM Driver.
3. Click Add/Remove and follow screen instructions.
Configuring the Terminal Adapter
Introduction
North American users must configure the terminal adapter to match
network switch type, the service profile identifier (SPID), and the
directory number (DN). For international users, the terminal adapter
ships already configured for NET3, which should work on most phone
lines in Europe. However, you may want to customize settings,
regardless of your location. (See “Optional Settings” on the following
page.)
You can configure the terminal adapters with the ISDN TA
Configuration utility, ConfigMenu, or with AT commands.
Instructions for all three are provided in this section.
• ISDN TA Configuration Utility—recommended for computers with
Windows 95/98 and Windows NT.
• ConfigMenu—recommended for computers with DOS or Windows
3.x and a VT100/ANSI compatible terminal or data communication
program that includes VT100/ANSI terminal emulation.
• AT Commands—allow you to fine tune TA operation with AT
commands and S-registers. Enter these commands in your data
communication program’s terminal mode. AT commands are
described in detail in the online manual.
North American Users
Before you connect the ISIHP-2S/2U to your network terminator, you
must configure it to match the following:
• Network Switch Type ____________________
Select the network switch type your ISDN service uses at its local