Multi-Tech Systems ISIHP-2U - Manual (Page 58)

Software/Driver Installation
58 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD
18. The first TA now is configured. Click Back to return to the
Configuration dialog box and repeat steps 4 through 9 to
configure the remaining TA(s). If you install multiple ISIHP cards
in the same PC, you must configure two TAs per 2S or 2U card
installed or four TAs per 4S or 4U card. For example, if you install
four ISIHP-2S/2U cards in one PC, you have to configure eight
TAs (two per card).
29. After all TAs are configured, close the ISDN TA Configuration
utility.
ConfigMenu Configuration Utility
The ConfigMenu configuration utility can be used as another means of
configuring the TA. ConfigMenu is installed in the TAs as part of the
firmware.
To use ConfigMenu:
1. Start a data communication program and select the COM port
where the TA is connected.
2. In the communication program dialog box, type AT@CONFIG
and press ENTER. ConfigMenu’s Main Menu appears (see screen
below).
3. To select menu item, type its number and press ENTER. A
submenu then appears where you can make selections. At the
lowest level, you can change a configuration option by selecting a
number or typing a value and pressing ENTER.