Multi-Tech Systems ISIHP-2U - Manual (Page 138)

138 MultiModemISI Hybrid Series, ISIHP-2S/2U/4S/4U/4SD
Terminal Adapter AT Commands & S-Registers
Canceling a Call
To cancel a call before the TA makes a connection, press any key.
Storing a Telephone Number
To store a telephone number, type &Zn=x in terminal mode, where n is the
number of the memory register in which the number is to be stored, and x is the
dial command string that you want to store. For example, type AT&Z9=612-
785-3500 <cr> to store the number 612-785-3500 in memory register 9.
Dialing a Stored Telephone Number
To dial a stored telephone number, type DS=n in terminal mode, where n is
the location of the number you want to dial. For example, type ATDS=3
<cr> dials a telephone stored in memory register 3 location.
Displaying a Stored Number
To display a stored telephone number, type &Zn? in terminal mode, where
n is the memory register where the number is stored. For example, type
AT&Z5? <cr> to display the telephone number in memory register 5. To
list all ten telephone numbers stored in memory, type ATL <cr>.
Answering a Call
You can answer incoming calls to the TA either manually or automatically.
When the TA detects an incoming call, it turns on the RI signal on the V.24
interface and sends a RING result code to the computer or terminal after
each ring. If you enable autoanswer, the TA automatically answers the call.
To manually answer the call, use the A command.
Answering Manually
If your communication program is in terminal mode when the RING result
code appears on your monitor, manually answer the call by typing ATA
<cr>.
Answering Automatically
To set the TA to answer a call automatically :
1. Enable autoanswer by setting register S0 to the ring on which you
want the TA to answer (e.g., in terminal mode, type S0=4 to make
the TA answer on the fourth ring). You also can use one of the
configuration utilities to the turn autoanswer on and set the number