JVC GET0602-001A - Manual (Page 133)

3
ELECTRICAL CONNECTIONS
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious
damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in color.
1 Connect the colored leads of the power cord in the order specified in the illustration below.
2 Connect the antenna cord.
3 Finally connect the wiring harness to the unit.
1
2
3
Typical connections /
* 1 Not supplied for this unit.
* 2 Before checking the operation of this unit prior to installation, this lead must be connected, otherwise power
cannot be turned on.
* 1
* 2
15 A fuse
15 A
Fan
Ignition switch
To a live terminal in the fuse block connecting to the car battery (bypassing
the ignition switch) (constant 12 V)
12 V
To metallic body or chassis of the car
To an accessory terminal in the fuse block
To the remote lead of other equipment (200 mA max.)
200 mA
To automatic antenna if any (250 mA max.)
250 mA
Fuse block
To cellular phone system
To car light control switch
Crimp connector
To parking brake (see diagram )
Yellow *2
* 2
Red
Orange with white stripe
Black
Light green
Brown
Blue with white stripe
Blue
Left speaker (rear)
( )
Right speaker (front)
( )
Left speaker (front)
( )
Right speaker (rear)
( )
Gray with black stripe White White with black stripe Green with black stripe Gray Green Purple with black stripe Purple
Rear ground terminal
To external components
(see diagram )
VIDEO IN
see diagram /
DIGITAL OUT
see diagram /
LINE IN
see diagram /
REAR OUT
see diagram /
see diagram /
Position data output /
SUBWOOFER—Only for KW-AVX726/KW-AVX725 / KW-AVX726/KW-AVX725
see diagram /
VIDEO OUT
see diagram /
Antenna terminal
This terminal is used for controlling an external device by using the touch panel of this unit. This unit outputs the positional
information detected on the touch panel through the POSITION OUT terminal. Refer to the instruction manual of the external
device for details. JVC does not guarantee proper operations for the external device connected to the POSITION OUT terminal.
POSITION OUT
JVC POSITION OUT
CT_Instal_KW-AVX726[UT]2.indb 3 CT_Instal_KW-AVX726[UT]2.indb 3 08/12/25 16:33:17 08/12/25 16:33:17