Troubleshooting, Connecting the parking brake lead, Connecting the external amplifier and/or subwoofer – JVC GET0602-001A User Manual

Page 145

Advertising
background image

3

A

Connecting the parking brake lead

Parking brake lead (light green)

To metallic body or chassis of the car

Parking brake switch (inside the car)

Parking brake

Connecting the reverse gear signal lead (for rear view camera)

Locate the reverse lamp lead in the trunk.

To car battery

Extension lead

*

1

Crimp connector

*

1

Purple with white stripe

*

1

Not supplied for this unit.

*

2

Firmly attach the ground wire to the metallic body or to the chassis of the car—to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit.

Reverse lamps

To reverse lamp

Reverse lamp lead

B

C

Connecting the external amplifier and/or subwoofer

You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.

Rear speakers

JVC Amplifier

Remote lead

*

1

Y-connector

*

1

Remote lead (blue with white stripe)

To the remote lead of other equipment or automatic antenna if any

Front speakers

Subwoofer

JVC Amplifier

Only for KW-AVX726/KW-AVX724

Crimp connector

Signal cord

*

1

Audio cord

*

1

TROUBLESHOOTING

• The fuse blows.
* Are the red and black leads connected correctly?

• Power cannot be turned on.
* Is the yellow lead connected?

• No sound from the speakers.
* Is the speaker output lead short-circuited?

• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?

• This unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?

• This unit does not work at all.
* Have you reset your unit?

Install2_KW-AVX726_010A_f.indd 3

Install2_KW-AVX726_010A_f.indd 3

12/30/08 9:45:31 AM

12/30/08 9:45:31 AM

Advertising