Names and functions of parts, Front panel – JVC BR-HD50 User Manual
Page 14
E-10
NAMES AND FUNCTIONS OF PARTS
Front panel
1
Cassette loading slot/LED
• For loading a cassette into or unloading it
from the slot.
Insert a standard DV cassette or a mini DV
cassette. (
• When BR-HD50 is in the OPERATE OFF
state and a cassette is loaded, it changes to
the OPERATE ON state.
• With a cassette loaded, the LED lights up in
green.
When a cassette is being loaded or ejected,
the LED flashes.
2
[OPERATE] button/LED
• Press this button to turn on the power and BR-
HD50 becomes ready for operation.
(OPERATE ON)
Press this button again when BR-HD50 is
already on to turn off the power. (OPERATE OFF)
• OPERATE LED lights up as follows.
OPERATE ON : the green LED lights up
OPERATE OFF : the red LED lights up
VCR error
: the red LED blinks
Memo
z
If DC IN MODE in the SYSTEM [2/2] Menu
screen is set to “OPE ON”, and power is sup-
plied to the DC IN terminal on the rear panel,
power is turned on and the unit enters OPER-
ATE ON mode without pressing this button.
z
Even after the power is turned off with this but-
ton, BR-HD50 is live with a small amount of
electricity.
Therefore, if BR-HD50 is not to be used for a
long period of time, please remove the AC
adapter to save energy.
3
[EJECT] button
• Press this button to eject the cassette.
Memo
z
It takes about 6 seconds for the cassette to be
ejected.
z
The cassette can be ejected even when BR-
HD50 is in the OPERATE OFF mode. After the
eject action is completed, BR-HD50 returns to
the OPERATE OFF mode.
4
Operation buttons
[REC] button/LED
• Hold down this button and press the PLAY
button to start recording. During recording,
the red LED lights up.
• Hold down this button and press the
PAUSE button to pause recording.
• If this button is pressed during recording, an
index signal is recorded on the tape (when
INDEX WRITE in the SYSTEM [2/2] Menu
screen is set to ON).
• When this button is pressed in the STOP
mode, the time code generator value can
be checked while the button is being held
down. If TC DUPLI. Menu is set to AUTO,
the time code, date and time of the
IEEE1394 terminal can be checked. (In DV
mode only)
2
1
3
4