JVC BR-HD50 - Manual (Page 50)

E-46
RECORDING
Recording procedure
1.
Load the cassette tape.
• Before loading the cassette tape, please ensure that the rear
slide of the cassette tape is pushed to REC.
The unit is turned on.
2.
Start recording.
• Press the PLAY button while holding down the REC button.
3.
Pause recording.
• Press the PAUSE button.
4.
Resume recording.
• Press the PLAY button.
5.
Stop recording.
• Press the STOP button.
If INDEX WRITE is set to ON in the SYSTEM [2/2] Menu screen, an index signal is recorded at the
recording starting position of the tape. In the PLAYBACK mode, the position where the index signal is
recorded can be searched. (Index search)
„ Press the REC button to record index signals during
recording.
* It is not possible to record only index signals after the record-
ing. Allow at least an interval of 1 minute between recordings
of index.
* Index signals cannot be recorded with the REC button of the
remote controller. Use the record button of BR-HD50.
2.
REC button
5.
STOP button
3.
PAUSE
button
2. 4.
PLAY button
Memo
z The tape protection function
enables BR-HD50 automati-
cally to go into the STOP
mode when there is a long
recording pause. The time to
go into the STOP mode can
be set with REC LONG P.
TIME in the SYSTEM [1/2]
Menu screen.
z When a home-use DV VCR
is used to play tapes record-
ed with BR-HD50, the sound
level may be reduced.
Recording index signals
Memo
If recording is performed right
after the RECORDING PAUSE
mode is exited, index signals
are not recorded.